Sentry US ACSK-EM Manual de usuario descargar pdf (Pagina 11)

REMOVING ALL USER & CODES

1. In Setup Mode, press * key and 8. The mode LED indicator will flash yellow.

2. Press 8 twice. A long beep means all users and their codes were removed (except

for Programming/Admin Code).

3. Press # key to exit Setup Mode.

CHANGING THE UNLOCK DELAY TIME

ZONE 1:

1. In Setup Mode, press * key and 1. The mode LED indicator will flash yellow.

2. Enter unlocking delay time from 00-99 (ex: 10 means ten seconds delay time before

it locks). A long beep means unlock delay time was adjusted. If setting lock-time is

00: swipe card or input password once and open the door, then swipe card for input

password again and close the door.

3. Press # key to exit Setup Mode.

ZONE 2:

1. In Setup Mode, press * key and 5. The mode LED indicator will flash yellow.

2. Enter unlocking delay time from 00-99 (ex: 10 means ten seconds delay time before

it locks). A long beep means unlock delay time was adjusted. If setting lock-time is

00: swipe card or input password once and open the door, then swipe card for input

password again and close the door.

3. Press # key to exit Setup Mode.

PICKPROOF ALARM

The built-in buzzer will send a continuous beeping if the photoresistor sensor is directly

exposed into the light. The buzzer will turn off automatically in 60 seconds. The light is no

longer detected by entering the programming/admin code.

To turn on:

1. In Setup Mode, press * key and 6. The mode LED indicator will flash yellow.

2. Press 0 and 2. A long beep will sound and the mode LED indicator will turn yellow

to indicate that pickproof alarm was turned on.

3. Press # key to exit Setup Mode.

To turn off:

1. In Setup Mode, press * key and 6. The mode LED indicator will flash yellow.

2. Press 0 and 1. A long beep will sound and the mode LED indicator will turn yellow

to indicate that pickproof alarm was turned off.

3. Press # key to exit Setup Mode.

Note: If the photoresistor is directly exposed into the light, a

buzzing sound will be heard. It will only stop upon removing

the light exposed directly to the photoresistor, the

Programming/Admin Code was pressed or after 60 seconds.

1 2 ... 6 7 8 9 10 11 12 13 14

Sin comentarios

Sentry US ACSK-EM Manual de usuario Pagina 11